I glued together two sticks together. I found some thin sticks for less than a buck at the craft store.
The glue was just to hold them in place. I went back over the center with some string to hold it tightly.
I then took the same string and wrapped it around each arm. I taped it to the sticks to hold it's shape.
I measured out the plastic tablecloth so it was about 11/2 inch extra around each side.
I taped it down. I also added two piece of tape in the middle on the back...
...and front.
I punched a hole and strung another string through this, tied it off, leaving it a little loose. This is what I attached the kite string too.
I added a string with a tail. I used some ribbon. This helps weight down the bottom so that it's heavier on the bottom and can catch some wind.
I also made some mini kites that I dangled from dowel rods and covered in some vintage looking fabric. ![](http://signatures.mylivesignature.com/54489/48/42ABBA4DE6FC5CE4AFA0F0B749A1B634.png)
No comments
Post a Comment